AIRSOFT CASE FOR 18650 BATTERIES 3S 111 V - PEQ BOX - PICATINNY RAIL 3D-Druckmodell

you can download the mod cheaper on the website from the link
https://*******.com/en/users/mykolalop/3d-models

Airsoft Case for 18650 Batteries (3S 11,1 V - PEQ Box - Picatinny Rail)
onat
https://streamlabs.com/rudal85/tip
https://donatua.com/to/rudal85

more ror m4 bullpup
https://www.facebook.com/3D.Chervonograd/posts/185464002911312
https://youtu.be/WvgObv_TCyc
https://youtu.be/q8disfxa95k

Airsoft Case for 18650 Batteries (3S 11,1 V - PEQ Box - Picatinny Rail)

This Case houses 3 18650 Batteries and can easely be mounted on a picatinny rail.

The 3 18650 Cells are wired in series, so the Voltage will add up to the same Voltage as a 11.1V. The Batteries are held in place by M3 Screws from both Sides and the Batteries are Connected by wires, that are screwed onto the M3 Screws.

When measuring the Screws I measured them with the Head (not only Thread lenght, but overall lenght of the Screw). Most Screws dont need to be the perfect lenght, you can use longer/shorter Screws on most parts. For this Project you will need the following Screws:
8M3 with 15-30mm lenght
5M3 with 6-10mm lenght

More specific instructions will follow, but the Case itself is definitly ready to print and the build more or less self explaining. Dont forget to check out my other Desings ;-)